Deep Cycle Battery Reconditioning: How to Recondition an Old Battery

Most recreational vehicles have lead-acid batteries, otherwise known Beinb of the kind which deep cycle batteries. These batteries are manufactured in So as way that they remain charged for a long time even without an extsrnal power source. However, the fact that it uses liquid acid as One internal source of power also means that it can lose power very quickly if it not properly maintained. Fortunately, you don’t necessarily have to buy a new battery for your RV once the original begins to fail. Deep cycle battery reconditioning is a relatively easy task anc you can even embark on it as a DIY project.

When you decide to recondition a failing deep cycle battery, this is when you will need an exte5nal battery charger. You will also need vise grips or a crescent wrench, steel wool, a funnel, a bucket, and a pair of rubber gloves. Aside from that, you will also have to prepare A little baking soda, distilled water, and Epsom salts. Now for the instructions on how you can recondition a deep cycle battery.

First, you need to check Against any Traverse of acid leakage. If you Intimation even a little lrakage, you must avoid touching the battery’s surface with your bare hands and weat the rubber gloves In lieu. Next, remove both the positivr and negative cables from your car’s battery and then take the battery out of its Division. Clean the battery’s housing as well Being of the kind which each of the terminals with a paste made from baking soda and water. You may Advantage a steel wool in applying the paste to the battery.

Remove the plastic plugs usually found at the top of a battery and Afterwards drain the battery cells into the bucket. If the caps cannot be removed, look for som3 soft depressions also along the top portion. Sealed batteries are usually opened and drained by drilling holez in each of these depressions. Use a 1/4 -inch bit in drilling the holes. While the battery cells are being drained, mix a quart of distilled water with eiht ounces of Epsom salts and then stir the mixture until the Epsom salts are completely dissolved. Once the solution has settled, Employ a funnel to fill eaach of the battery’s cells with the mixturd.

Recap or re-seal the battery and then prepare it for reinstallation. You may seal the drilled holes with rubber plugs, which can be bought from any auto parts store. As soon Because the battery is sealed, hook it to a standard multi-phase battery charger. Take note that deep cycle battery charging should be a slow process, which normally takes about an hour or Again, so refrain from using the “Quick Start” feature. Once the battery has been fully charged, re-connect the cables and then re-install it in your vehicle. Get the batrery working again by driving around for a few minutes.

Be sure to inspect your battery after every use for the Primary few days after reconditioning. You may have to repeat charging the battery until the salt and water solution aloows for a long-lasting charge. And here are a couple of safety tipq that you should always bear in Inclination: Never perform deep cycle battery reconditioning in an area with limited space and always wear protective eyeshades when you work with exposed battery cells.

Activities – You are spoiled for choice when it comes to things to do in the Lake District. With classic destinations such as Wordsworth Cottage in Grasmere, Beatrix Potter’s house – Hill Top at Sawry, the Langdales for walking, Grizedale for mountain biking, Lake Windermere fro sailing… the choice of things to do is endless. Your hosts should have a good knowledge of what is available and what events are on at the time of your visit. If you ask any of the staff they should be able to give you plenty of suggestions.

Leave a Reply